RYFA MINI CREEPER

The Mini Creeper is a rolling seat 6.75" off the floor. Low enough to sit at a wheel, a rocker panel, or the bottom of a door with your hands at the work and your knees off the concrete. Long enough, at 29.5", to stay planted when you lean in. On four 4" casters, two locking, so it rolls the length of the car and stops where you stop.
Turn the frame over, and it's a 10.75" stool for bumpers, lower doors, benches and baseboards: same steel, same seat, same trays.
Two removable MS trays ride at either end. The padded seat lifts off and becomes a knee pad—MIG-welded steel, rated to 181Kg / 400 lb, in black.

Ultra-low. So you don't have to kneel.

At 6.75", your eyes are level with the hub. Wheels and tires, brake dust, calipers, rocker panels, sills, the lower third of a door, PPF and vinyl on the bottom edge of a panel — the work is in front of you, not beneath you. Roll along the car, lock, work, unlock, roll. The frame is 29.5" long, and the seat sits inside its wheelbase, so leaning into a wheel doesn't lift a caster.

Load capacity — rated for the real load

Flip it—a low-height stool.

Turn the frame over, refit the four casters, and the dropped center becomes a raised one: a 10.75" stool for bumpers, headlights, lower doors, bench undersides, block sanding and cutting in a baseboard.

The seat is the knee pad.

Some work sits lower than any seat. Lift the padded seat off the frame and kneel on it — 16" × 12" of foam over a steel-backed base, wide enough for both knees. It presses onto the frame and lifts off in one motion, no tools. One unit covers sitting and kneeling, and it's never in two places.

Load capacity — rated for the real load

Four 4" casters. Two locks.

4" casters clear what stops smaller wheels — concrete seams, floor grit, an extension cord, a zip tie — and keep rolling under 181Kg / 400lb. Two caster locks, so the creeper stays put when you lean into a wheel or brace against a panel. Unlock both, and it glides.

Trays that travel with you.

Two MS trays sit at either end of the frame, at seat level, where a hand finds them without looking: polisher, pads, bottles, towels, sockets, fasteners. Each is bent from a single sheet, light and rust-proof, with a 0.8" (20 mm) upright lip that keeps what you put in from rolling out. Lift them off when the job doesn't need them.

Load capacity — rated for the real load

Welded steel. From the casters up.

One MIG-welded steel frame with a steel sheet deck under the seat. No plastic base to crack. No pressed board to break. It carries 181Kg / 400lb without flexing when you shift your weight, and it keeps you up off concrete, brake dust, and shop debris. Every Mini Creeper is loaded to 181Kg / 400lb before it's packed.

Lean in. It stays put.

Long enough to be planted, narrow enough to work beside the car. It slides under a low bench, sits alongside a wheel arch, and follows a door without a footprint that gets in the way. Four casters at the corners of a 29.5" frame and a seat 6.75" off the floor: it doesn't tip, and it doesn't roll out from under you.

Load capacity — rated for the real load

One hard skin. Wipes clean.

It's finished in the same grade of powder coat that goes on building steel — railings, façades, street furniture — cured as one hard skin over the welded frame. Dropped sockets, dragged trays and a floor full of grit don't mark it. Polish, compound and brake dust wipe clean.